Standard SPI Interface (3.3V)
BUS Interface for automotive
The System Uses SPI(Serial Peripheral Interface Bus) communication to control high-speed automotive LED headlights and to detect errors using I2C(Inter-Integrated Circuit) communication. All Interfaces was designed in Verilog HDL, based on Philips I2C, SPI Standard Mode. The implemented LED controller System was verif..
The Serial Peripheral Interface (SPI) Controller is a synchronous serial interface useful for communication with other peripheral or microcontroller devices. These peripheral devices may be serial EEPROMs, shift registers, display drivers, A/D converts, etc. The SPI Controller is compatible with Motorola’s SPI and SI..
SPI master for MAX 3421(USB controller)
This IP is 4-wire SPI master interface for MAX 3421E (USB controller). It is specially modified for max 3421 controller, so it have some different parts compare with basic SPI master interface. For example, ‘SS’ signal is drive low at least 16 bit when TX/RX.
For easy to use this IP in AMBA system, this module ha..
SPI Master/Slave Controller
The SPI(Serial Peripheral Interface) is serial, synchronous, full duplex communication protocol. It is widely used as a board ?level interface between different devices such as a micro controller, DACs, ADCs, and others. The SPI controller is typically used as an SPI master, but it can be configured as an SPI slave as ..